All safety circuits must be implemented purely electromechanically or with certified electronic parts that are not included with this breakout-board. Depending on the evaluation of the machine s risk level, it may be required to install additional protection devices, such as door locks or safe halt guards. Failure to do so could result in damage to mechanic or electronic components, or lead to personal injuries. Please read this manual thoroughly and carefully follow all instructions. Ģ 1 Safety Instructions The installation of this breakout-board should only be carried out by qualified personnel. All terminals are pluggable for easy installation and maintenance. Adaptors or special cables for Leadshine stepper drives and SanyoDenki Servo systems are also available. BEAST and UHU drives can be connected directly. Industrial proximity sensors can be connected directly. All output signals are buffered and all inputs in the machine side are designed for 24V to provide maximum noise immunity. Depending on the jumper settings, additional features like control of a frequency inverter, relay outputs, Z-axis holding brake output, safety watchdog (charge pump) and limit switch inputs are available. It can be set to many different configurations using jumpers. This requires the use of a CNC controller software (not included), such as like Mach3, WinPCNC, EMC² or USB- CNC. 1 Mini CNC Interface for LPT Port Version 4 Product Brief This breakout-board is designed to connect up to four stepper or servo drives to the parallel port of a PC.
0 Comments
Leave a Reply. |